Topic: Adding drivers at new setup installation

[gatox]

URGENT !!!!

Need help to install a PROMISE SX4000 Lite ATA RAID card driver at initial install.  

WHen system asks if you want to load a driver from a floppy and select "Ok" then nothing happens or Anaconda keeps on loading till it gives an error "No devices were found to install filesystem".

Need to get this thing going, cause I need a NAS of 4x 200Gb ATA/133 RAID 5 config.

If SME is not able then will switch to RHat AS 3.0/9.0, Suse 9.x or as a last resort -> Windoze 2003  .  

Any comments or hints are more than welcomed.
[/b]

Best regards,

Luis

[ldkeen]

This is the procedure I used to get an unsupported scsi controller detected at boot time. http://www.comnetel.com/bootdisk.htm You could modify it to work with this adapter.

[keasley]

I also need the drivers.  Please assist in this issue.  TIA.