My Internal tape drive died today so I put an External USB IOMEGA REV drive on my SME 6.X Server and booted up.
Tapeware sees the device, I configured it to use this device, did a backup, no problems.
I am just concerned about the following info from the dmesq log, most importantly the warning part.
Can anyone tell me if this is all ok?
Thanks,
Dan
ehci-hcd 00:10.3: VIA Technologies, Inc. USB 2.0
ehci-hcd 00:10.3: irq 12, pci mem f8867000
usb.c: new USB bus registered, assigned bus number 1
PCI: 00:10.3 PCI cache line size set incorrectly (32 bytes) by BIOS/FW.
PCI: 00:10.3 PCI cache line size corrected to 64.
ehci-hcd 00:10.3: USB 2.0 enabled, EHCI 1.00, driver 2003-Jan-22
hub.c: USB hub found
hub.c: 6 ports detected
hub.c: new USB device 00:10.3-2, assigned address 2
usb.c: USB device 2 (vend/prod 0x59b/0x41) is not claimed by any active driver.
SCSI subsystem driver Revision: 1.00
Initializing USB Mass Storage driver...
usb.c: registered new driver usb-storage
scsi0 : SCSI emulation for USB Mass Storage devices
Vendor: Iomega Model: RRD Rev: 74.B
Type: CD-ROM ANSI SCSI revision: 02
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 2
USB Mass Storage support registered.
EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,3), internal journal
kjournald starting. Commit interval 5 seconds
EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,1), internal journal
EXT3-fs: mounted filesystem with ordered data mode.
0 Replies
665 Views