Once more exuce me for knowing absolutely nothing about your project before jumping into it at this forum.
I have now installed what I downloaded to be a SME 7.0 R1
Configuration panels says SME 7.0 R2
uname -r says 2.6.9-34.EL
Actually, I don't know for sure if i run R1, R2 or R1.5
On this installation i installed the folloving rpms:
selintra-sail-2.1.11-187.noarch.rpm
smeserver-asterisk-1.2.3-2.i686.rpm
smeserver-asterisk-sounds-1.2.2-2.noarch.rpm
smeserver-asterisk-zappri-MPP-1.2.2-1.i686.rpm
Hardware is an old P III / 800 single processor
I also have gone trough my router setup to eleminate problems here.
This time all installations went smooth and I could test your selintra-sail and the Asterisk rpms as well.
I think that there might be no doubt that you have done a great job in this project to integrate Asterisk into the sme server and then to keep the alternative to do a manual configuration as an option (By not using the selintra-module.) (I hope I have understod it right.)
What I ment somwhere above when I said that integrating the Asterisk controls into the server-manager vould mess up the SME server, I was actually thinking about the integration of Asterisk@home into the SME server that has also been done. This will allvays be "a bit messy" I think.
It looks for me like that the selintra-sail installation is made much more acording to the design priceples that the SME server is built up around.
On the other side - it must be really difficult to integrate al those technologies that is into the sip/iax telephony into one graphical control panel. I guess that this will be more easy later on as technology (and configurations) will tend to standardize (??)
But the manual configuration is still there as a option, and that is great.
When it comes to my small problems or intability with the DISA function, this seems to be related to someting more "Asterisk server deeper thing".
I get these errors in the log:
May 4 23:58:36 NOTICE[3531] rtp.c: Comfort noise support incomplete in Asterisk (RFC 3389). Please turn off on client if possible. Client IP: 64.24.214.24
The DISA function works ok when called from a local phone. It's only from my mobile phone I get some instability. The problem repieted when I tested with SME 6.0.1 and the old Asterisk RPM from 2004. On the oter hand - for some strange reason Astlinux with the identical same configuration files does not have a problem at all. I will try to find out about this a a more specific Asterisk server problem, as I think it is.
I guess that your Asterisk integration for the SME server will run in a stable way that will not affect the server in a negative way. (Will now try to test it out.
Thanks for a great job.
By the way, is it possible to download your Sark iso for testing ?
(My mail: heiarne_at_gmail_dot_com)
Best reg Arne.