Topic: DECT not ringing

[edeganay]

SME 7.2, SAIL 2.1.15-502
1 sip trunkline
6 SIP internal extensions 5000-5005
3 softphones, 1 thomson ST2030, one Linksys PAP2 with 2 analog phone (one fixed, one mobile)

the mobile is a DECT phone, Sagem D26T

When the handset is receiving a call, it just doesn't ring, and nothing appear on its screen.
However, it can be used for outgoing calle without any problem.

Do you see something to do for this ?

Thanks,
Edd

[SARK devs]

Hi there

Difficult question to answer.  Asterisk will send a SIP invite to the PAP2.  What the PAP2 then does with it "downstream" is not known to Asterisk.  If it were me, I would first send a call to the DECT and watch what happens on the asterisk console.  Let's say, for example, that your DECT is at 5004.  You should see asterisk issue a "ringing 5004" message at the console.  If you do, then the problem is with the settings on your PAP2 (which will almost certainly be the case).  The PAP2 can be set with varying impedences and voltages for various telephone standards throughout the world.  It is probable that you do not have the ring voltage or impedances set correctly for your Sagem phone (I am guessing you need to set it for the France Telecom standards). 

Kind Regards

S

[edeganay]

This is what it happens, and your answer sounds logical.
Now, let's find this parameters in the PAP2T management interface maybe the worst easy thing to do !

What is intersting to say is that, when the call is incomming, the asterisk control panel is showing it, and if I just push the "ok" button of the DECT, I get the call...even if nothing appear on the handset screen.

Thanks,
Edd

[edeganay]

found,

in the PAP2T admin page,
in "régional" menu
in "Ring and Call Waiting Tone Spec" section,

change sinusoidal with trapezoidal

hope this helps