Topic: [ANNOUNCE] smeserver-sysmon

[skovsgaard]

I'm preparing a new dual cobbermine server planned overtaking my old and well serving systems hard job. So I'm started with some initial configuration before migrating for good. lmsensors and sysmon are giving me some more grey hair.

This is the output of sensors, after trying to adjust sensors.conf to collect my voltage consumption:

lm87-i2c-0-2e
Adapter: SMBus PIIX4 adapter at 0580
ERROR: Can't get IN1 data!
ERROR: Can't get IN3 data!
ERROR: Can't get IN4 data!
fan1:     6193 RPM  (min = 2848 RPM, div = 2)
fan2:     6429 RPM  (min = 2848 RPM, div = 2)
temp1:       +27°C  (low  =    +0°C, high =   +65°C)
ERROR: Can't get TEMP2 data!

lm87-i2c-0-2d
Adapter: SMBus PIIX4 adapter at 0580
ERROR: Can't get IN1 data!
ERROR: Can't get IN3 data!
ERROR: Can't get IN4 data!
fan1:        0 RPM  (min = 2848 RPM, div = 2)          ALARM
fan2:        0 RPM  (min = 2848 RPM, div = 2)          ALARM
temp1:       +24°C  (low  =    +0°C, high =   +65°C)
ERROR: Can't get TEMP2 data!


I have no problem not collecting the voltage meassurements, is there a way hiding/removing/deleting the voltage graph in sysmon. In sysmon only the data lm87-i2c-0-2d is collected, and not the fans and temp from lm87-i2c-0-2e. Can I manipulate system monitor to show these data in the existing graphs?

Any advice on this

[pmstewart]

In another week or so I'll be upgrading to the new SME version on a different test bed server. I will attempt to post my results as the mb I'm using on the test server has the piix4 chipset on it.

I haven't been working on computers for 6 months - busy taking care of other business - sorry for the delay in post.