Topic: How to disable Array Sopport after SME 7.4 installation is complete

[veebr0]

Dear, friends, I couple day ago I installed a fresh SME 7.4 installation on a IBM X3200, this server conatain a internal array controller so I configure it as array 1 by hardware.

The problem is that I forged to install SME server without the array option, this mean I alway in this type of server I install SME with the option sme no raid.

My question is, Exist a possibility to disable this option after the SME  server was installed.

Thanks for your advice.
Eviny

[Stefano]

hi

no, AFAIK you can't.. you'd backup, reinstall, restore

[veebr0]

I suspected it since the principle 

Thanks Stefano for your prompt replay.

You cannot change The past , but if to learn of the. 
EB.

[CharlieBrady]

no, AFAIK you can't..

You also don't need to. Software RAID (with a single 'device') works fine over hardware RAID.

[veebr0]

Yes, Charlie agree with you, but was my mistake to install SME server with array support, normally when I do SME installation on Servers that support arrray (IBM, HP, DELL) by hardware I just created only one logical array via hardware and install the SME server without the array support option.

Thanks for your advice.
Eviny

[Stefano]

You also don't need to. Software RAID (with a single 'device') works fine over hardware RAID.

indeed Charlie, but it adds a layer that, IMVHO, is useless.. isn't it?

[CharlieBrady]

indeed Charlie, but it adds a layer that, IMVHO, is useless.. isn't it?

Useless but harmless.