Hello, I'm installing a fog mirror server but I would like to stay using the sme 7 dhcp server. (
www.fogproject.org) fog server is on other hardware than sme server.
In the fog installation manual I could find that I have to make a change in the dhcp.conf file wich is normally in /etc
******************* fog manual ************************
Linux
If you would like to use an existing Linux based DHCPD server you will need to perform the following steps:
1.Edit your dhcpd.conf file (ie: vim /etc/dhcpd.conf)
2.In the global section or in a subnet declaration add next-server X.X.X.X; and filename "pxelinux.0"; where X.X.X.X is the IP of your FOG server.
3.Restart your dhcpd server (ie: service dhcpd restart)
******************* end fog manual *********************
But when I try to change the dhcp.conf I see that I cannot change it because it will be restored after restart etc... and that I have to read the developers manual.
In the developers manual I could find that I have to expand the files (if I don't misunderstood it).
I've edited the file etc/e-smith/events/bootstrap-console-save/templates2expand/etc/dhcp.conf with the two lines mentioned above
and I've created a dhcp.conf in /etc/e-smith/events/reboot/templates2expand/etc/dhcp.conf
When I rebooted the sme server and restarted the workstation I see that PXE is starting but I get an pxe error file not found.
I hope you can understand my English and my question and I hope to receive a solution
Best regards
Wilfried