Now i installed OpenFire on SME10.1
my prerequisites:
- took the howto from sme9.2 (
https://wiki.koozali.org/Openfire) as starting point
- I took OpenFire in 64bit version
- no installation of glibc needed, sme includes the right one
- since OpenFire version 4.70 OpenFire isn't bundled with java any more
here the steps I made:
- wget
https://github.com/igniterealtime/Openfire/releases/download/v4.7.4/openfire-4.7.4-1.noarch.rpm- yum install openfire-4.7.4-1.noarch.rpm
Openfire start:
- /etc/rc.d/init.d/openfire start
After that you can proceed the installation in the browser:
-
http://myserver:9090/I proceeded as in the tutorial for sme 9.2:
- at the encryption options i choosed AES
- at the database options i choosed the "Embedded Database"; it's ok because i have only a few users
- at "Profile Settings" i took LDAP as in the tutorial
After finishing the setup in the browser-based frontend i changed to shell:
- config set openfire service TCPPorts '5222,5223,7777' access public status enabled
- signal-event remoteaccess-update
Then configuring starting with system:
ln -s /etc/rc.d/init.d/e-smith-service /etc/rc.d/rc7.d/S99openfire
That was all, I could connect xmpp from intern and extern IP.
Can anyone verify this? Then the Howto can be published for SME10.
Greetings, Uli