Koozali.org: home of the SME Server
Legacy Forums => Experienced User Forum => Topic started by: Aaron Held on April 26, 2001, 03:30:13 AM
-
I am trying to connect via a 3Com cable modem on the Cablevision network in NJ with no luck. The dhcpcd keeps timing out, I increased the timout setting and played with some other hostname options but no luck.
Has anyone else experinced this?
I checked the command line being called by /sbin/ifup and it seems that it is always calling dhcpcd with a switch -h accountname entry
I went through the DHCP How-To's without much luck.
Any pointers?
Thanks,
-Aaron Held
-
I woke up this morning and the eSmith connected to the cable modem the first time.
I was plugging my laptop directly into the modem and renewing the DHCP lease fairly often to go online and read something. When I do that eSmith cannot obtain a response. If I unplug the modem for a few minutes (not just a few seconds) everything works fine.
Thanks
-Aaron
-
Aaron Held wrote:
>
> I woke up this morning and the eSmith connected to the cable
> modem the first time.
Naturally. We have hundreds of people all over the world on various cable modem systems working perfectly.
> I was plugging my laptop directly into the modem and renewing
> the DHCP lease fairly often to go online and read something.
> When I do that eSmith cannot obtain a response. If I unplug
> the modem for a few minutes (not just a few seconds)
> everything works fine.
The cable system uses DHCP, and will remember the MAC address of your laptop. You are lucky it is a few minutes - it is frequently many hours/days before your lease will expire.
Let e-smith handle the cable modem, and put your laptop on the e-smith internal interface.
Gordon
-
Your right,
if I release the lease from the laptop it works much better.
I built the server at work and tested it against a netware DHCP server, I needed to bring it home to test the cable modem.
Thanks again,
-Aaron