Koozali.org: home of the SME Server

Legacy Forums => Experienced User Forum => Topic started by: Andrej on November 27, 2002, 10:23:58 PM

Title: Problem using Darell's APCUPSD
Post by: Andrej on November 27, 2002, 10:23:58 PM

Hello !

I have been using SME 5.5 with APCUPSD 3.8.2 without server-manager integration without any problems. Becouse I set up new SME 5.5 box I set up NEW Darrell's contrib. Installation was OK, server-manager menu etc ... But I get an error when I wan to check URL http://www.pcklinika-sp.si/cgi-bin/multimon.cgi for monitoring. I am using SmartUPS conected with original APC cable...

Andrej

Title: Re: Problem using Darell's APCUPSD
Post by: Boris on November 28, 2002, 07:44:24 AM

try http://yourservername/cgi-bin/multimon.cgi

Title: Re: Problem using Darell's APCUPSD
Post by: Andrej on November 28, 2002, 11:19:55 AM

Tx! I find problem in my config. Now works everything well in MASTER - SLAVE config between two SME servers.

Andrej

Title: Re: Problem using Darell's APCUPSD
Post by: Graham on November 28, 2002, 10:47:56 PM

I see they are 3.8.5 now - I have 3.8.2 and the DMC rpm to go with that.

Is it ok to use what I have on SME 5.5 [SP1]

The small APC UPS is coming tomorrow.

Any general or specific advice welcome.

ps I don't need any fancy monitoring as long as
it shuts the system down gracefully.

Thanks.

Title: Re: Problem using Darell's APCUPSD
Post by: Andrej on November 28, 2002, 11:10:43 PM

I always prefer to get SMS on my mobile, so I know how much time(which and when) my or our clients servers will stay on-bateries and when they are back on mains ?! Those fancy monitoring give you a bonus if you are on remote side of network ...
Sometimes is better not to know, so you are not afraid of ether ...

Everything works 100% if you are not so sure that you have UPS on COM1 (but it is on COM2) that you even not think to look at the back of server [ :( ] . Conect and use Darrell's contrib. I's great

Bye,

Andrej