Koozali.org: home of the SME Server

Legacy Forums => Experienced User Forum => Topic started by: spock on December 29, 2002, 05:25:52 PM

Title: speedtouch pro nat entry
Post by: spock on December 29, 2002, 05:25:52 PM

i have a question about nat ,i have setup the adsl modem etc ,i telnet too the modem and entered nat defserver addr X.X.X.X into the modem everything was working fine ,then when i went to check the connection to the server using a dial-up connection a few hours later i couldnt log on to the server ????  i telnet to the modem again and there was no defserver listed ? i re entered the command as above and all is well again .can someone please explain why i had to re-enter it again .thanks  spock

Title: Re: speedtouch pro nat entry
Post by: Barry Rogers on January 23, 2003, 08:52:28 AM

suffered this one too...
when you have set the defserver, use the command 'save' at the 'nat' prompt.
then it will keep the change when you reset the modem.