Koozali.org: home of the SME Server

Legacy Forums => Experienced User Forum => Topic started by: guestHH on February 15, 2003, 11:47:49 PM

Title: mini-tix
Post by: guestHH on February 15, 2003, 11:47:49 PM: Just want to report full success with the mini-itx fron VIA.

Installed e-smith 5.6 on a via epia5000 (533Mhz).

Regards,
guestHH
Title: Re: mini-tix
Post by: guestHH on February 15, 2003, 11:48:11 PM: I mean VIA mini-itx...

:-)
Title: Re: mini-tix
Post by: Jim Danvers on February 16, 2003, 01:28:11 AM: See here for a project that this guy did some time ago using this board and SME. ;)

http://www.mini-itx.com/projects/gascanpc/

-=- jd -=-
Title: Re: mini-tix
Post by: RayG on February 16, 2003, 05:40:00 AM: I started running SME 5.1 on a EPIA-800 several months ago. I recently rebuilt the machine with SME 5.5 and have had no hardware related problems.

It's good to hear you have 5.6 working. And with the fanless Eden processor! Have you run into any performance issues ? Some people are suggesting the minimum hardware requirements for SME have gone up a bit with 5.6.
Title: Re: mini-tix
Post by: Anthony Suddaby on February 16, 2003, 07:05:00 AM: I've got e-smith 5.5 on a 800 MHz VIA mini-itx.

I've got two Seagate Barracudas in a software raid config.

I am trying to sort out why it is extremely slow serving files. It appears that there's a small burst, then a wait then some more etc.. The switch it's running into is 100Mbps autosensing, and I'm using the standard VIA Rhine NIC driver. I expected a performance hit with writing and software raid, but I'm not sure why it's slow reading.

regards
--
Anthony Suddaby
Title: Re: mini-tix
Post by: guestHH on February 16, 2003, 12:00:10 PM: No issues, just runs perfectly.
Title: Re: mini-tix
Post by: Andrej on February 16, 2003, 12:09:09 PM: Yeap, here is another Setup running SME 5.6 on VIA EPIA 800MHz with 256MB RAM, old FUJITSU 10GB (for testing it will be replaced in near future with WD-8MB cache) RIA Ethernet for WAN and Natinal Semi. 10/100/1000 Eth for LAN (it is LevelONE Giga Card). Everything is running OK. I have Hylafax instaled too (with ext. modem) and works great.

Before I set this up I try to check If this box can riun as an ISDN gateway using ASUS ISDN internal CARD for DialUp gateway (in this case is RIA Eth used for LAN of course). Well everything works OK in this case too.

I am going to set up VPN for Local Pharmacy with this boxes (fileserver, gateway etc). You will hear all reports HowTo-s If needed...

Cheers,

Andrej
Title: Re: mini-tix
Post by: Ed Form on February 16, 2003, 02:26:34 PM: Anthony Suddaby wrote:
>
> I've got e-smith 5.5 on a 800 MHz VIA mini-itx.
>
> I've got two Seagate Barracudas in a software raid config.
>
> I am trying to sort out why it is extremely slow serving
> files. It appears that there's a small burst, then a wait
> then some more etc.. The switch it's running into is 100Mbps
> autosensing, and I'm using the standard VIA Rhine NIC driver.
> I expected a performance hit with writing and software raid,
> but I'm not sure why it's slow reading.

There is some kind of problem with SME 5.6 and Seagate Barracudas in software mirror setups, or just with Seagate Barracudas i software mirrors. The usual symptom is that the install takes hours.

Ed Form
Title: Re: mini-tix
Post by: RayG on February 16, 2003, 09:46:23 PM: "I am trying to sort out why it is extremely slow serving files. It appears that there's a small burst, then a wait then some more etc.. "

I ran into that on my first install of 5.1 and the problem turned out to be a bad IDE cable. There was a warning at boot saying something to the effect of "no 80 pin cable detected on the primary IDE channel" which motivated me to change the cable. I still see the pauses to some extent but the transfers are at least 4 times faster than they were before the cable change.
Title: Re: mini-tix
Post by: Paul van Dun on February 17, 2003, 12:40:44 AM: I use my VIA-EPIA 800 for testing and compiling and so far no problems what so ever with this board.

Regards,

Paul van Dun
Title: Re: mini-tix
Post by: guestHH on February 17, 2003, 12:59:41 AM: Good to know Paul :-) We'll talk about it off-list.

Regards,
guestHH
Title: Re: mini-tix
Post by: Anthony Suddaby on February 18, 2003, 11:29:25 AM: Thankyou for your suggestions on reading slowness from Seagate barracudas.

I'll try without RAID (and update to v5.6 at the same time).

regards
--
Anthony Suddaby
Title: Re: mini-tix
Post by: tanyu on March 17, 2003, 06:52:03 PM: I've got some problems on via 800mhz mini-itx with the lan card which seems to hang sometimes when I submit a large amount of data (copying a large file to samba ibay or user's home for instance). The server does not hang, neither does samba, but the networks gets down.
It's with a 5.5 issue.
Does anybody knows if there's a better driver than the standard via-rhine for the built-in lan interface ?
Title: Re: mini-tix
Post by: Andrej Fercic on March 17, 2003, 07:51:11 PM: I am running ver 5.6 without any problems at all. I will go for an uprade instead of new driver ?!

Andrej