Koozali.org: home of the SME Server
Legacy Forums => Experienced User Forum => Topic started by: rob on February 24, 2003, 01:56:09 PM
-
Hi - I've installed SME 5.6 (as a first time user).
However, the modem (Netcomm Roadster 336) will not connect to my ISP. Normally, I the call length is 2-3 seconds before it hangs up.
I recorded a working Window 2000 pc connect to the 'net - see below
------------------------------------------
ATDT0,69538600
CONNECT 33600
**** Terminal Server *****
Login:btech
Password:mypassword
PPP Mode blah blah blah
----------------------------------------
But if I replace the modem with a terminal, and emulate a modem, I only get as far as 'CONNECT', and ask SME for a login name, but it doesn't reply. Not sure if CD is required to be asserted on RS232 - tried - doesn't seem to matter.
The ISP assigns my IP address dynamically.
Tried
-config of SME server as server/gateway or server/gateway (private)
-different modem
-reinstallation of SME o/s
-registering compression modules (ppp-compress-21)
Messages LogFile:
Feb 22 20:37:44 server chat[2625]: send (ATD0,69538600^M)
Feb 22 20:37:45 server chat[2625]: expect (CONNECT)
Feb 22 20:37:45 server chat[2625]: ^M
Feb 22 20:38:15 server chat[2625]: ATD0,69538600^M^M
Feb 22 20:38:15 server chat[2625]: CONNECT
Feb 22 20:38:15 server chat[2625]: -- got it
Feb 22 20:38:15 server diald[1164]: connector: chat: Feb 22 20:38:15 CONNECT 33600
Feb 22 20:38:15 server diald[1164]: Connected to site 0.0.0.0
Feb 22 20:38:15 server diald[1164]: Running pppd (pid = 2626).
Feb 22 20:38:15 server diald[2626]: Running pppd: /usr/sbin/pppd -defaultroute -detach modem crtscts mtu 1500 mru 1500 name btech noauth noipdefault ipparam diald
Feb 22 20:38:15 server pppd[2626]: pppd 2.4.2b1 started by root, uid 0
Feb 22 20:38:16 server pppd[2626]: Using interface ppp0
Feb 22 20:38:16 server pppd[2626]: Connect: ppp0 <--> /dev/ttyS0
Feb 22 20:38:16 server /etc/hotplug/net.agent: assuming ppp0 is already up
Feb 22 20:38:16 server modprobe: modprobe: Can't locate module ppp-compress-21
Feb 22 20:38:17 server kernel: PPP Deflate Compression module registered
Feb 22 20:38:17 server modprobe: modprobe: Can't locate module ppp-compress-21
Feb 22 20:38:17 server pppd[2626]: Connection terminated.
Feb 22 20:38:17 server diald[1164]: failed to read ppp interface status: No such device
Feb 22 20:38:17 server pppd[2626]: Exit.
Feb 22 20:38:18 server /etc/hotplug/net.agent: NET unregister event not supported
Feb 22 20:38:18 server diald[1164]: stop ppp0: Cannot find device "ppp0"
-
Rob, I am experiencing the same problem although with different modem. Furthermore I have the situation where it worked with 5.5, but fails with 5.6. Same cpu, same modem, same cable, same isp, same account--works with 5.5 does not work with 5.6. My point of failure is same as yours "Can't locate module ppp-compress-21" disconects after 1 or 2 seconds.
-
Gary
Thanks for your reply. It does seem obvious that the software IS at fault.
I wonder what what can do about getting around this?
Go back to 5.5?
Get e-smith to sort it out?
Rob
-
just like to jump on the bandwagon - i too have the same problem - dial up worked fine with 5.4, now fails on 5.6 with the can't find ppp-compress problem. Any ideas yet?
-
sorted it - searched on google, found this fix :
Message 2 in thread
From: chandrasekhar (chand6ce@ccs.iitb.ernet.in)
Subject: Re: ppp-compress-xx error
View this article only
Newsgroups: linux.redhat.install
Date: 2000-11-19 08:17:57 PST
On Sun, 19 Nov 2000, Paul Lewis wrote:
>
> Connect PPP0 <--> /dev/modem
> Can't locate module ppp-compress-21
> Can't locate module ppp-compress-26
> Can't locate module ppp-compress-24
Hi
You can turn them off by adding these lines in /etc/conf.modules ( or
modules.conf)
alias ppp-compress-21 off
alias ppp-compress-26 off
similarily for the next one..
end of quote
if you mod the modules.conf file and switch the compresses alias' to off, the dial up should work as usual again - mine does :)
hope this helps (ps i meant 5.5 rather than 5.4 above - too much wine...)
-
I to am having this problem on a new 5.6 install. HOWEVER I have tried the suggested mods to the modules.conf and modprobe still insistes on calling for the -21 compress mod. Any other suggestions ??? Deaparate here.
Simon