Koozali.org: home of the SME Server
Legacy Forums => Experienced User Forum => Topic started by: molski on March 28, 2003, 12:57:34 AM
-
Hi Guys,
I am trying to install a printer for the very 1st time on e-smith, but I ran into some (stupid??) problems. I attached the printer to the 1st USB port and created the printer through the server-manager. After rebooting, I get this error:
Mar 27 22:44:49 brain kernel: usb.c: registered new driver usbdevfs
Mar 27 22:44:49 brain kernel: usb.c: registered new driver hub
Mar 27 22:44:49 brain kernel: usb-uhci.c: $Revision: 1.275 $ time 15:25:44 Jun 10 2002
Mar 27 22:44:49 brain kernel: usb-uhci.c: High bandwidth mode enabled
Mar 27 22:44:49 brain kernel: usb-uhci.c: USB UHCI at I/O 0xef80, IRQ 10
Mar 27 22:44:49 brain kernel: usb-uhci.c: Detected 2 ports
Mar 27 22:44:49 brain kernel: usb.c: new USB bus registered, assigned bus number 1
Mar 27 22:44:49 brain kernel: usb-uhci.c: v1.275:USB Universal Host Controller Interface driver
Mar 27 22:44:49 brain kernel: usb.c: registered new driver hiddev
Mar 27 22:44:49 brain kernel: usb.c: registered new driver hid
Mar 27 22:44:49 brain kernel: usb.c: USB device 2 (vend/prod 0x43d/0x57) is not claimed by any active driver.
Mar 27 22:44:38 brain /etc/hotplug/usb.agent: ... no modules for USB product 43d/57/100
Mar 27 22:44:38 brain /etc/hotplug/usb.agent: ... no modules for USB product 0/0/0
Mar 27 22:45:22 brain lpd: Warning - lexmark: cannot open lp device '/dev/usb/lp0' - No such device
Mar 27 22:45:58 brain e-smith[2321]: Running event handler: /etc/e-smith/events/local/S10module-load-usb-printer
Mar 27 22:45:59 brain e-smith[2321]: modprobe: Can't locate module usb-controller
Mar 27 22:46:00 brain kernel: usb.c: registered new driver usblp
Mar 27 22:46:00 brain kernel: printer.c: usblp0: USB Bidirectional printer dev 2 if 0 alt 0 proto 2 vid 0x043D pid 0x0057
Mar 27 22:46:00 brain e-smith[2321]: S10module-load-usb-printer=action|Event|local|Action|S10module-load-usb-printer|Start|1048801558 713576|End|1048801560 42606|Elapsed|1.32903
Can someone help me with this ? I thought it was a lot easier installing a printer on a e-mith machine :( Is it also necessary to install te cd drivers from the printer onto the clients, or can that be left away ?
My regards,
Molski