Koozali.org: home of the SME Server

Legacy Forums => Experienced User Forum => Topic started by: Ron on September 12, 2003, 02:49:32 AM

Title: Enable raid - Add second drive
Post by: Ron on September 12, 2003, 02:49:32 AM

I have recently lost one of my drives that were installed in a raid configuration. While waiting for the replacement, I reformatted and installed SME6beta3 on a single drive. I have now recieved the second drive back and would like to now put the second drive into my system, and enable Raid support.

I have searched Contribs.org, but have been unable to find a how-to to make this happen. Any help will be appreciated.

Title: Re: Enable raid - Add second drive
Post by: Ray Mitchell on September 12, 2003, 04:57:15 AM

I am assuming you are meaning software RAID1

The general procedure is:
Do a full backup, and make sure you verify it.

Instal your second HDD, first disk as primary master and second disk as secondary master
Do a fresh instal of sme OS and configure as RAID1
Restore your backup

You cannot convert a single disk non RAID to a software RAID1 configuration. Software RAID1 can only be setup at instal time.

Regs
Ray

Title: Re: Enable raid - Add second drive
Post by: roger on September 12, 2003, 03:10:19 PM

I have had success converting from non-raid to both RAID1 and RAID5  by following this HOWTO - using a standard 5.6 kernel and (better still) by compiling a custom kernel:

 http://www.tldp.org/HOWTO/Boot+Root+Raid+LILO-4.html

Roger