Koozali.org: home of the SME Server

Legacy Forums => General Discussion (Legacy) => Topic started by: Ren on June 04, 2001, 02:10:04 PM

Title: OnStream support ?
Post by: Ren on June 04, 2001, 02:10:04 PM

I want to connect my OnStream 30 USB model to the e-smith server.
Does anyone have some experience with this?

rene

Title: Re: OnStream support ?
Post by: Vince on June 07, 2001, 04:44:04 AM

This was a topic a few months ago. At the time the driver wasn't supported by e-smith. Have you contacted On-Stream for a more recent driver?

I thought they may have closed their doors.

V

Title: Re: OnStream support ?
Post by: Donald E. Stidwell on June 12, 2001, 07:36:32 AM

Linux kernels 2.2.17 and above are supposed to have the Onstream support built in, and there are kernel patches for 2.2.14 and 2.2.16. You can patch your e-smith kernel with the 2.2.16 patch (of course you'd have to install the kernel sources and compiler) and then use the taper module for your backups.

The 2.4.x kernels also have the Onstream support in the kernel that best work with the ide-scsi interface and the /dev/osst and /dev/nosst devices. I have an Onstream drive that I'm using contentedly with SuSE 7.1 (2.4.2 kernel) and Taper. However, since I have a SCSI drive for my e-smith box, I see no compelling reason to plop the OnStream drive in it.

Honestly, getting an OnStream device working on e-smith probably would not be a big deal if you know how to compile a kernel and apply patches. I don't know if the flexbackup will work with it, but there's either a how-to or rpm for Taper that you can use from the backup module of the e-smith module (check www.esmith.org).

Don

Title: Re: OnStream support ?
Post by: kees on June 14, 2001, 01:19:07 AM

http://linux1.onstream.nl/

drivers OnStream