Koozali.org: home of the SME Server
Legacy Forums => General Discussion (Legacy) => Topic started by: craig coulson on June 20, 2001, 02:14:49 PM
-
we have an e smith box running happily as a gateway machine with an analogue dial up. it all works fine.
we have now moved to a 64k isdn dial up and have procured the LASAT SPEED 2 isdn modem. this works fine on our winbloze machines, but refuses to work on e-smith (i was lead to believe by these forums that they should just work)
however the thread below mentions some files need changing :-
http://forums.contribs.org/index.php?topic=1792.msg5956#msg5956
i know the lasat works with linux - it is stated on their website :-
http://www.eicon.com/support/helpweb/lasat/faq47.asp
Note concerning Speed II:
According to present experiences, the LASAT Speed II modem works without any need to patch a file. Should you experience otherwise, we would like to hear about it.
The procedure should be as follows:
The ISDN TA can be set to use 2 strings:
String 1: AT\P1&B2&D0 (RFC 1662)
String 2 ATQ0
Automatic modem detection is not advisable, in stead you should manually correct the file /etc/wvdial.conf
We suggest that you configure the first 7 lines as follows:
Modem = /dev/ttyS2 (COMport installation)
Init1 = AT\P1&B2&D0
Init2 = ATQ0
Phone = ISP phonenumber
Username = ISP username
Password = ISP password
Baud = 115200
where do i make these changes ???
detailed instruction would be nice as im struggling to get to grips with e-smith :)
please help..
thanks in advance
-
craig coulson wrote:
> The procedure should be as follows:
>
> The ISDN TA can be set to use 2 strings:
> String 1: AT\P1&B2&D0 (RFC 1662)
> String 2 ATQ0
>
> Automatic modem detection is not advisable, in stead you
> should manually correct the file /etc/wvdial.conf
...
> where do i make these changes ???
See the FAQ entry re modem init strings:
http://www.e-smith.org/faq.php3#8q11
Regards
Charlie