Koozali.org: home of the SME Server

Legacy Forums => Experienced User Forum => Topic started by: Marco Garza on December 12, 2003, 11:39:00 PM

Title: SME 6.0 Final and Squid
Post by: Marco Garza on December 12, 2003, 11:39:00 PM

On the three installs that I have done of this software so far, Squid keeps giving me an error about the local lan ip range being put in the acl localsrc and acl localdst lines.  I went into squid.conf and removed the duplicate ip entries on those lines.  Will try to see if this is a problem in the templating system or what.  Anyone else experience this?

Title: Re: SME 6.0 Final and Squid
Post by: Charlie Brady on December 13, 2003, 10:06:50 PM

Marco Garza wrote:

> On the three installs that I have done of this software so
> far, Squid keeps giving me an error about the local lan ip
> range being put in the acl localsrc and acl localdst lines.

It would help if you reported the actual error message, and where and when you see it.

Charlie

Title: Re: SME 6.0 Final and Squid
Post by: marco on December 19, 2003, 09:47:59 AM

After doing a fresh install of SME 6.0 Final, look at /etc/squid/squid.conf.  The local lan ip group is listed on the acl localsrc and acl localdst lines twice.  I really can't tell where it is duplicating this entry.

Title: Re: SME 6.0 Final and Squid
Post by: jb on December 26, 2003, 04:36:12 AM

Yeah, I have that too.  I have been looking at
/etc/e-smith/templates/etc/squid/squid.conf/20ACL10localhost, but am unable to see if this is the culprit or not.

JB