Koozali.org: home of the SME Server

Legacy Forums => General Discussion (Legacy) => Topic started by: Anonymous on March 05, 2004, 10:02:41 PM

Title: dhcp problems
Post by: Anonymous on March 05, 2004, 10:02:41 PM

I have just recently done a clean install of 6.0 (previously using 5.5). Some clients (win98, winxp) that previously obtained an ip address from the dhcp server no longer do so. Others (win2000) do! Nothing changed on the clients. A ping to the SME server (192.168.10.1) results in "host unreachable.." error. Yet if I manually input the ip/gateway settings in the client - all is fine! Any clues where to start looking? Many thanks.

Title: Re: dhcp problems
Post by: bushinc on March 06, 2004, 03:59:44 AM

> I have just recently done a clean install of 6.0.
> Some clients (win98, winxp) that previously
> obtained an ip address from the dhcp server no
> longer do so.

Look at:
 service dhcpd status

You might try:
/sbin/e-smith/signal-event post-upgrade
/sbin/e-smith/reboot

If that doesn't work, go through the configuration on the server.  Disable DHCP, then enable.  Maybe change the IP address range that SME gives out.

I haven't had this problem, so I'm not sure what the problem is.

Title: dhcp problems
Post by: shanen on March 06, 2004, 06:15:28 AM

You could try the following:
Xp - From the command line
ipconfig /release
ipconfig /renew

Win98
Start button
Run
winipcfg
Change to your ethernet interface and renew