Koozali.org: home of the SME Server

Legacy Forums => General Discussion (Legacy) => Topic started by: John Crisp on August 09, 2001, 04:11:25 AM

Title: Installation switches ?
Post by: John Crisp on August 09, 2001, 04:11:25 AM

Hi, Am trying to get e-smith onto a Gigabyte board with Promise ATA 100 Raid controller. I can install other distros with

linux ide2=0xdc00, 0xd802  (I/O from from lspci etc.)

This works fine. How do I do the same with e-smith at the "accept" prompt ? Will it take commandline switches ? Or is there a hack ?

ANy ideas gratefully received.

B. Rgds

John

Title: Re: Installation switches ?
Post by: trevor on August 09, 2001, 10:27:38 AM

There is a contributed HOWTO on installing using the Promise ATA!00 board at http://www.e-smith.org/docs/howto/contrib/ata100.txt

Hope this helps
Trevor B
John Crisp wrote:
>
> Hi, Am trying to get e-smith onto a Gigabyte board with
> Promise ATA 100 Raid controller. I can install other distros
> with
>
> linux ide2=0xdc00, 0xd802  (I/O from from lspci etc.)
>
> This works fine. How do I do the same with e-smith at the
> "accept" prompt ? Will it take commandline switches ? Or is
> there a hack ?
>
> ANy ideas gratefully received.
>
> B. Rgds
>
> John

Title: Re: Installation switches ?
Post by: John Crisp on August 09, 2001, 09:40:14 PM

Many thanks for that - looks similar sort of procedure to other installs I have done - just couldn't quite pin it down.

B. Rgds
John