Koozali.org: home of the SME Server

Legacy Forums => General Discussion (Legacy) => Topic started by: Nic on May 12, 2004, 03:39:45 AM

Title: SME6.0 Server only Change to Server and Gateway
Post by: Nic on May 12, 2004, 03:39:45 AM

HI

  I'm running a SME 6.0 web server(hosting few domains) behind the SME 5.6 (Server and gateway) as my
firewall. Not sure this is a good solution or not.

  Now i think runing my web server(sme 6.0) act as a  server and the gateway. So if i re run the setup can i change server only to server and gateway or do i need to install again.

Or tell me the proper solution, Thanks

Title: server setup
Post by: gbaird on May 12, 2004, 05:36:23 AM

Hello

you can just go through your server setup again

start from the console it is item 2

you will need 2 networks cards to use it in gateway mode
to the full potential