Koozali.org: home of the SME Server

Legacy Forums => Experienced User Forum => Topic started by: paulmancan2 on August 11, 2004, 07:46:32 PM

Title: hdc: irq timeout: status=0xd0 { Busy } ....
Post by: paulmancan2 on August 11, 2004, 07:46:32 PM

I recently noticed my software raid 1 was toast but didn't believe the drive was bad. I forced a rebuild on hdc and everything seems to be fine (a few days now.)

I do notice the msg in this subjected repeated with some frequency in my log followed by:
ide1: reset: success.

Does this necessarily mean that there is some hardware problem? Thanks!

Title: hdc: irq timeout: status=0xd0 { Busy } ....
Post by: NickR on August 13, 2004, 02:18:54 AM

I've seen this also & it seems to be on AMD boards with a VIA chipset & certain makes of HDD, although I can't really be definite.  The chances are good the array will break again, IME.

I now put both disks on the same channel & that seems to make the problem go away.

Title: hdc: irq timeout: status=0xd0 { Busy } ....
Post by: paulmancan2 on August 13, 2004, 05:23:28 PM

Thanks... it is a DELL mobo based on Intel BX chipset + PIII...

I am thinking that perhaps the drive is spinning down/sleeping?

Anyhow I opened the case and replaced the IDE cables... The errors haven't appeared yet so we will see...

Title: hdc: irq timeout: status=0xd0 { Busy } ....
Post by: Brave Dave on August 15, 2004, 11:31:27 AM

I reliably get this problem with the Seagate U5 series Hard Drives

I don't get this on Seagate Barracudda's

Been some time since I have seen up, but also been some time since I used a U5