Koozali.org: home of the SME Server

Legacy Forums => Experienced User Forum => Topic started by: daryl on August 18, 2004, 07:24:12 PM

Title: Dell PE400SC
Post by: daryl on August 18, 2004, 07:24:12 PM

I have seen a few messages in here about the Dell PE400SC servers.  I'm courious if anyone here has actually installed on one recently with any sucess or headaches.

I was also looking at the IBM x206 but the SATA looks like it will cause more of a headache.

Title: Dell PE400SC
Post by: bushinc on August 31, 2004, 09:02:28 PM

I have several PE400SC servers running.
I'm using them as SME and IPCOP servers.
(not using the SATA interface on SME or IPCOP)

I also have several setup as servers running windows 2003.

They've had no problems so far.

Title: Dell PE400SC
Post by: Boris on August 31, 2004, 09:26:24 PM

I have installed half of dozen of them this summer. Two for myself. Use IDE (not SATA). Zero problems. I recommend to my friends and clients to use them as workstations as well. Nice, stable, quiet and fast system.

Title: Dell PE400SC
Post by: ryan on September 03, 2004, 11:08:05 PM

I run 6 PE400 with SME 6.01-01...no probs.  If your going to use 5.6, there is an rpm to allow sme5.6 to recognize the 1000mb onboard nic.

ryan