Koozali.org: home of the SME Server

Legacy Forums => General Discussion (Legacy) => Topic started by: treyh on February 26, 2005, 03:35:00 AM

Title: 1 NIC+2 ip's (Server and gateway)
Post by: treyh on February 26, 2005, 03:35:00 AM

Here is what I want to do and have already done.

I have...
Sme Server 6 Running as gateway and server

I set the internal address to be 192.168.0.x and the external address to be 69.8.x.x

I only have 1 NIC installed on the box. I can only access one of the ethernet interfaces at a time. It depends on if I switch e0 or e1 around from normal or to switched.

Is it possible for me to run both the local and public interfaces on 1 NIC? Is there a different trick to it?

Title: 1 NIC+2 ip's (Server and gateway)
Post by: cc_skavenger on February 26, 2005, 06:05:18 AM

what exactly are you trying to do with this server.

Title: the deal
Post by: treyh on February 26, 2005, 07:12:37 AM

I am using it as a vpn server.

I just need to know if it's possible to put both the lan and wan (eth0 and eth1) on the same nic. If it's not, just say so.

Title: 1 NIC+2 ip's (Server and gateway)
Post by: cc_skavenger on February 26, 2005, 08:05:02 AM

Just trying to understand the situation.  This is not possible if you are trying to use it as a vpn server.  The setup does not allow for two gateway IPs on the same nic.  I would setup the server as a regular server/gateway.

You can setup the server as a server only setup and use it as a vpn server, but it would give you an IP in the range of the wan address.  

Sorry, I guess I don't understand why you would want to do this.

Title: finally
Post by: treyh on February 26, 2005, 09:05:15 AM

Thank You. This is what I wanted to knmow

"The setup does not allow for two gateway IPs on the same nic."

I'll put another NIC in it monday morning