Koozali.org: home of the SME Server
Legacy Forums => General Discussion (Legacy) => Topic started by: whalley on June 11, 2005, 07:35:48 PM
-
I have a server only SME server set up for my home. I would like to be able to get it through my MR814 wired, and wireless router. I am unsure as to how to accomplish this.
I have set up the server this way
Router IP address 192.168.0.1 (Gateway)
Server address 192.168.0.54
I can access the server from other computers on the network, but the router is not showing it in the "attached devices" view in it's setup.
Thanks in advance
[/b]
-
Are you trying to access the internet from the server or you trying to access the server from the internet?
Also, if you set a static IP on the server and have DHCP enabled on the router.....
1-Make sure you set the IP on the server outside the DHCP range on the router.
2-The server may not show up on the router's "attached device list" unless it supplies the IP to the server dynamically.
-
Also make sure you enter the IP of your router as the gateway for the server to use. Made this mistake just earlier today. I was going through the configuration too fast and misread the question.