Koozali.org: home of the SME Server

Legacy Forums => Experienced User Forum => Topic started by: mindea on August 30, 2005, 04:07:24 PM

Title: FlexBackup to workstation
Post by: mindea on August 30, 2005, 04:07:24 PM

It seems to me I have seen an article somewhere that shows how to configure a server to run Flexbackup but instead of backing up to tape, it connects to a workstation's hard drive and puts the backup file there. Can anyone point me to this article? I swear it was on Contribs, but I can't find it. It might have been somewhere else.

Thanks,

Mindea

Title: FlexBackup to workstation
Post by: slicknic on August 30, 2005, 06:57:15 PM

I'm not so sure about an article, but you can find the Contrib here...

http://mirror.contribs.org/smeserver/contribs/dmay/smeserver/6.x/contrib/backup2ws/

Title: FlexBackup to workstation
Post by: mindea on August 30, 2005, 10:45:39 PM

That's it!. Thank you. Installed in minutes and works perfectly.

Title: FlexBackup to workstation
Post by: rf131 on September 01, 2005, 03:08:41 PM

Questions about the flexbackup contrib...

1.  Local disk.  Will it backup to a local disk, say an external USB drive?  I'm considering this for our backup device.
2.  Pre and Post Install Scripts.  Can I invoke a umount on the drive after backup is completed?  This will allow my client to disconnect and connect the new drive, and with automount in place SME will find the new drive and mount it, making it ready for the next backup job.
3.  The Panel.  How sophisticated is the panel?  Can I do a selective restore from the panel?  If anyone has a screen shot of the panel I would appreciate a link to some examples.

TIA and HAND -- Kevin