Koozali.org: home of the SME Server

Legacy Forums => General Discussion (Legacy) => Topic started by: jarthurs on October 07, 2005, 05:45:43 PM

Title: How do I pass use prompt parameters during 6.0 install?
Post by: jarthurs on October 07, 2005, 05:45:43 PM

I'm trying to install SME 6.0 onto an Compaq server with EISA which requires me to use a memmap=exactmap and a whole host of other stuff.

Where can I add these boot parameters as it never stops at a prompt?

Regards,
Jason.

Title: Re: How do I pass use prompt parameters during 6.0 install?
Post by: CharlieBrady on October 07, 2005, 05:58:34 PM

Quote from: "jarthurs"

I'm trying to install SME 6.0 onto an Compaq server with EISA which requires me to use a memmap=exactmap and a whole host of other stuff.

Where can I add these boot parameters as it never stops at a prompt?

Hold down the shift key before it starts booting. Then type "accept memmap=exactmap" (IIRC).