Koozali.org: home of the SME Server
Legacy Forums => General Discussion (Legacy) => Topic started by: Tim on December 06, 2001, 06:35:21 PM
-
Still looking for help, PLEASE!
I have just installed a preferred Tape Backup and configured it for backup. I am getting the following messages:
FROM: Cron Daemon
SUBJECT: Cron /sbin/e-smith/backup
MESSAGE: Backup aborted: No tape loaded
There is a new and clean tape in the drive.
Anyone have any thoughts?
-
I have had this problem and found that if you have used a controller card that does not have its own BIOS on-board the tape is not detected by E-Smith.
I replaced the card that I had with another low end Adaptec PCI card with a BIOS and then reinstalled the system as it was a new install anyway.
Everything worked fine.
Regards
Craig