Koozali.org: home of the SME Server

Legacy Forums => General Discussion (Legacy) => Topic started by: amicheals on December 14, 2005, 03:21:16 AM

Title: can't view server manager from the internet
Post by: amicheals on December 14, 2005, 03:21:16 AM

Hi everyone,

I am not very knowlegeble in programming or linux.  However, i wanted to install the SME SERVER because it had all of the function I was looking for.

I have a problem, I have installed SME SERVER 6.01 on the box.  I have also gone through the configuration and everything is okay however, I cannot  access the server manager from the internet.

I have a netopia 3347wvm router (with dchp turned on) with 5 ip address.  My ip addresses are 72.149.70.122 -126.  


During configuration I did leave the majoriy of the default settings because no computers are networked with the server as yet but i did put in the ip addresses my isp gave me.

when I try to access my server via ip address, I don't get anything.  It's a blank screen.

Please tell me what I am doing wrong.

Also, The server is setup in server gateway mode with dchp turned off because I was going to have the router do that.

Any help is appreciated.

Thanks
Amy

Title: Re: can't view server manager from the internet
Post by: CharlieBrady on December 14, 2005, 04:05:57 AM

Quote from: "amicheals"

I have a problem, I have installed SME SERVER 6.01 on the box.  I have also gone through the configuration and everything is okay however, I cannot  access the server manager from the internet.

That's what you should expect. By default the server manager is only accessible via the local network.

Title: can't view server manager from the internet
Post by: amicheals on December 14, 2005, 06:26:47 AM

Thanks for your reply,


Is there any way i can set the server up to be accessed directly from the internet without being on the network?

Thanks
Amy

Title: can't view server manager from the internet
Post by: funkusmunkus on December 14, 2005, 07:12:50 AM

You can either VPN to the server, and that would mean your on the local network, or you could go to”remote access” and add a new remote management network (which would be the IP address your going to use to access server-manager from, and use a mask of 255.255.255.255 that way it would only accept access from your ip address.

Hope that helps :-)
cheers

Title: Re: can't view server manager from the internet
Post by: raem on December 14, 2005, 07:49:54 AM

amicheals

You should read the manual.
If you had already read it, then you would not have needed to ask this question.
See Documentation link on left.