Koozali.org: home of the SME Server

Legacy Forums => General Discussion (Legacy) => Topic started by: billmakr on December 16, 2005, 07:54:30 PM

Title: during boot kernal panic kill init
Post by: billmakr on December 16, 2005, 07:54:30 PM

installing sme 6.0.1 on new intel 3ghz ht cpu based server. dual maxtor 80gb hdd's. I choose to install with raid option and install goes well. when reboots I get a screen full of errors ending with this statement "kernal panic kill init" have done search on this in group but the two posts are the same and refer to raid card. please help. could ht cpu cause this ?

thanks
billmakr

Title: during boot kernal panic kill init
Post by: irian on December 16, 2005, 11:31:08 PM

Sounds like a hardware problem.
It is too new for SME 6.0.1

Irian

Title: not compatible new hardware?
Post by: billmakr on December 17, 2005, 10:12:30 AM

are you saying that sma will not run on modern hardware?
what hardware is compatible with sme 6.0 and would 7.0 solve this issue or is it also limited to old hardware too?

thanks
billmakr

Title: too new hardware
Post by: billmakr on December 21, 2005, 06:54:59 AM

update: i did install sme7.08 b and ran ok. must be some problem with 6.0.1 and esc 800m motherboard.

billmakr

Title: during boot kernal panic kill init
Post by: dwheiman on January 06, 2006, 02:02:06 AM

I too had 7.0.8 running on an older 40gb Maxtor. When I upgraded to an 80gb Maxtor, 7.0.8 hangs just as billmakr describes. I dropped back to 6.5 and everything is running fine on the 80gb.