Koozali.org: home of the SME Server
Legacy Forums => General Discussion (Legacy) => Topic started by: mongolito404 on February 10, 2002, 08:28:51 PM
-
Hoi,
I had a e-smith 4.1 running fine for months. I just upgraded it with VME 5.1.2. The upgrade process went without any problem. But now my server doesn't boot anymore without using the rescue floppy created at the end of the upgrade process.
When I try to boot from the hd lilo displays only LI and hangs.
I've read in the FAQ that it's a hd geometry problem but i didn't change my hd config during the upgrade and my system ran fine until I upgraded. I tried re-running LILO but it doesn't change anything.
I'm using software RAID1.
Here is my /etc/lilo.conf
---start of /etc/lilo.conf---
boot=/dev/md0
map=/boot/map
install=/boot/boot.b
prompt
timeout=50
message=/boot/mitel.pcx
linear
default=esmith
---end of /etc/lilo.conf---
Here is the output when running lilo.
---start of output---
boot = /dev/hdc, map = /boot/map.1605
Added esmith *
boot = /dev/hda, map = /boot/map.0305
Added esmith *
---end of output---