Koozali.org: home of the SME Server

Legacy Forums => General Discussion (Legacy) => Topic started by: Stefan Sabolowitsch on April 27, 2002, 08:11:44 PM

Title: Problems with the installation of a Modules.
Post by: Stefan Sabolowitsch on April 27, 2002, 08:11:44 PM

Hello
As I install also for a SME 5.12 the Modul e-smith-aliases.rc.rpm. With the instruction rmp -Uvh..... is installed unfortunately nothing. Which wrong I make.

thx

Stefan

Title: Re: Problems with the installation of a Modules.
Post by: Andrew on April 28, 2002, 05:45:46 PM

G'day Stefan,

I am only a newbie myself but I can tell you that if you did type "rmp -Uvh" then that could be your problem.  Try "rpm -Uvh".  If that doesn't work you are going to need some real help.

Cheers,
Andrew.

Title: Re: Problems with the installation of a Modules.
Post by: Stefan Sabolowitsch on April 28, 2002, 09:12:00 PM

Hello Andrew.
thanks for your rapid answer.  Sorry, in my first Mail were many write errors, I were in hurry.  Surely that is correct with "rpm", and not "rmp".  Which I looked for was as I "source of rpm" to be installed can.  Meanwhile I found the solution.  "rpm -- rebuild" is the solution.
Again thanks for your answer.  
I am still beginner with Linux.  Probably rather an expert with NT, and for me is to be been it a hard piece of work in this new world by right.  But I I will NT more and more unfaithfully, and become acquainted with the many advantages of Linux and to estimate.
And the change is easier for me with the SME server and this super forum.   Complement to the developers for your good work.

Stefan