Koozali.org: home of the SME Server
Obsolete Releases => SME Server 7.x => Topic started by: mcoops on June 04, 2009, 08:57:23 AM
-
Hi,
I have a problem after reinstalling a machine that had previously been running SME server I now find I cannot ping to or from the server.
The test internet access failes
The machine installed with no issues
The boot says eth0 is ok. There is only 1 nic in the HP Proliant ML110 machine
The server is configured as server only, the be a DHCP server. The IP addresses of the router & network are correct.
I have checked all the cables etc.
The ethtool command looks ok but for the last line that says Link detected: No
What am I missing?
TIA Mark
-
what's the output of
ifconfig eth0
?
is it correct?
did you restore a backup or is it a fresh setup?
Ciao
Stefano
-
Hi Stefano,
The ifconfig eth0 looks OK
I did a format & reinstall using sme 7.4 disk then used the backup when asked. That went in OK then rebooted.
Mark
-
ok..
try to go to console and reconfigure your server.. I think you'll do twice to confirm the right lan config.
if it doesn't work, raise a bug, thank you
Ciao
Stefano
-
Hi,
Got it sorted now. sorry to waste your time, its been a long week.
The problem was down to me. The ML110 has a second RJ45 socket on the back for iLo2. I was plugged into that....
Mark
-
Hi,
Got it sorted now. sorry to waste your time, its been a long week.
The problem was down to me. The ML110 has a second RJ45 socket on the back for iLo2. I was plugged into that....
Mark
ROTFL
well.. it's coffee time, isn't it? :-)
Ciao
Stefano