Koozali.org: home of the SME Server
Obsolete Releases => SME Server 7.x => Topic started by: cipandales on October 14, 2009, 03:25:02 PM
-
Hello !
I tried to install SME 7.4 on a new machine (hp dc5700 microtower) with 2 sata disks (500 gb, both).
It takes 2 hours to install. And, of course, everything i do, it takes very long.
I cheked up in bios for SATA controler settings and i don't have the option to change the SATA controler to work in AHCI mode (as is described in http://forums.contribs.org/index.php?topic=44306.0).
I've set the jumpers to 150/mbps transfer rate and is the same speed.
Can you help me, please ?
Thanks
-
Hi. Sometimes, the AHCI mode is called enhanced, or native. Do you have something like that ?
-
Hi !
I modified in bios, at /device configuration/transfer mode = enhanced hdma option, as you recomended.
Also, /device configuration/multisector transfers = 16 and /device configuration/translation mode = automatic.
But there is no improvements. I gave up after 40 min of installer at 55 %.
There is another possibility ?
Thank you
-
Well, there are some other possibilities:
- the slowdown may not be caused by the disks. you can see what's going on once it's installed, just log in with ssh and run "htop", it's a very nice process manager, you may find some informations
- there may be a fake RAID option in your motherboard which conflicts with the software RAID. Try to install with only one disk pluged in, and see if it's better.
Regards, Daniel
-
I also tried with 1 disk. Also tried with SME Sever 8 with 1 and 2 disks.
The same long installation.... bad luck.
With ubuntu 9.04 server, for example, it takes 30 minutes the hole instalation (Make raid, install ISP Config, for example).
Thank you for your time
-
I also tried with 1 disk. Also tried with SME Sever 8 with 1 and 2 disks.
The same long installation.... bad luck.
With ubuntu 9.04 server, for example, it takes 30 minutes the hole instalation (Make raid, install ISP Config, for example).
Thank you for your time
so it's a driver issue.. search for Centos Hp dc5700 issues
next time, check hw compatibility before spending money and time ;-)
-
Thanks cipandales for posting this question and thanks Stefano for suggesting the driver issue.
I have had the same issue with a DC7700 - and no success. However, thanks to the power of google, I believe I have solution for you.
Try this option at the cd install menu - pci=nommconf - it worked great for me. It has something to do with the onboard graphics card and memory allocation I believe. Make sure the BIOS is in AHCI mode otherwise it will be slower at formatting.
Hope this helps.
RIFF.
-
Hello !
Thanks for all replies !
I installed Sme Server with pci=nommconf and again with pci=nommconf acpi=off.
It took the same time as usual and after installation, the read/write on the sata hardisks it is very slow - it takes 2 or 3 times like another server for every settings.
Another opinion ?
Thanks a lot !
-
I have read your manual, and I suggest look under: Storage options, sata emulation menu.
manual:
http://bizsupport1.austin.hp.com/bc/docs/support/SupportManual/c00765925/c00765925.pdf (http://bizsupport1.austin.hp.com/bc/docs/support/SupportManual/c00765925/c00765925.pdf)
Good Luck.
p.s. i had to use pci=nommconf for it to work in my dc7700.