Koozali.org: home of the SME Server

Legacy Forums => General Discussion (Legacy) => Topic started by: Robert Adams on June 16, 2002, 05:34:01 AM

Title: RPM Install - cannot execute binary file
Post by: Robert Adams on June 16, 2002, 05:34:01 AM

I installed SME 5.1.2 onto a PC with a celeron 800-512ram with a 1 gig IDE Solid State Drive. Installation went very fast ;-)), however to install my normal contributed rpms I get the error "cannot execute binary file" Normally I can SSH and run Midnight commader to get stuff installed on a traditional Hard Drive. Is it possible that I have too little swap space, or a rights issue? any input would bet very helpful!

Thanks Very Much!

Bob Adams

Title: Re: RPM Install - cannot execute binary file
Post by: Lloyd Keen on June 16, 2002, 02:53:50 PM

See the section related to "Allow admin command line...." http://e-smith.org/docs/manual/5.1/admin-remoteaccess.html#ssh

Title: thanks Lloyd
Post by: Robert Adams on June 16, 2002, 08:44:44 PM

Thanks Lloyd for your help - especially on a weekend ;-), I will give it a shot today


Bob Adams