Koozali.org: home of the SME Server
Obsolete Releases => SME VoIP (Asterisk, SAIL etc) => Topic started by: portedaix on July 18, 2010, 04:02:33 PM
-
Hello,
My problem : When I connect with SJPhone from a windows station to asterisk, it registrers but shows the message NAT/Firewall : blocked.
I am an asterisk newbie, but tried my best for 2 days now! I am setting up asterisk and sail on sme 7.5.1. in servergateway mode.
I followed the contrib http://sarkpbx.com/twiki/bin/view/Main/DocChapter03b and other docs.
asterisk is up and running. I have created extensions. I see them in sail with a tick box. Shouldn't it be a "plug icon", when fully connected ?
I cannot dial outside at the moment, but it ok from extension to extension.
There is no other firewall than smeserver one on my network.
I have been looking high and low to find out what could block the outgoing connection, I found nothing.
So far, in my route, the dialplan is _X! just to make sure that it does not stop calls, if I am not mistaken.
Thanks for help.
-
Shouldn't it be a "plug icon", when fully connected ?
Only if you are running a class C network and you have dynamic proxy turned on. Otherwise, a checkmark (tick) is fine.
If your extensions can call one another then Asterisk and sail are good.
If you really do have a route dialplan of _X then it won't dial anything except single digit numbers. Incidentally, it's not a good idea to create a dialplan with fewer digits than your etension numbers, otherwise you run the risk that everything, including internal dials, will get shunted out the trunk.
It's always a good idea to have the asterisk console open when you test so that you can see exactly what Asterisk is doing with your dials.
Kind Regards
S