Koozali.org: home of the SME Server

Legacy Forums => General Discussion (Legacy) => Topic started by: Jáder Marasca on August 01, 2002, 06:37:40 PM

Title: unable to start hdparm service
Post by: Jáder Marasca on August 01, 2002, 06:37:40 PM

Hi,

I´m unable (I don´t know how to) start hdparm service.
I already used  config setprop hdparm status enable   on /etc/rc.d/init.d
but it still don´t start.
I already changed status order from 40 to 41 because another service was starting at same number...
I can configure hdparm using command line parameters, and boost my HDD from 1.83 to 31.37 but I´d like to have hdparm starting automatically and not use my solution: put hdparm command at end of xinetd!

Could please someone tell me where I´m doing something wrong... because I now I´m the wrong , not SME!

Thanks!

Jáder

Title: Re: unable to start hdparm service
Post by: Bill Talcott on August 01, 2002, 08:31:07 PM

Jáder Marasca wrote:
>
> I already used  config setprop hdparm status enable   on
> /etc/rc.d/init.d
> but it still don´t start.

http://www.myezserver.com/downloads/mitel/howto/hdparm-howto.html
"/sbin/e-smith/config setprop hdparm status enabled"

It's not just a typo, is it?  Putting "enable" instead of "enabled"...

Title: Re: unable to start hdparm service
Post by: Jáder Marasca on August 01, 2002, 10:04:56 PM

Bill Talcott wrote:
 
> It's not just a typo, is it?  Putting "enable" instead of "enabled"...
It was! I´m so sorry! JUST A TYPO!!!
It´s amazing how many times I checked the command line...

Thank you a lot!

I´m getting my hdparm -t on 31.37 MB! Thanks!