Koozali.org: home of the SME Server

Obsolete Releases => SME 8.x Contribs => Topic started by: newburns on July 28, 2014, 11:57:49 PM

Title: Pydio upgrade from Ajaxplorer
Post by: newburns on July 28, 2014, 11:57:49 PM

The installation instructions did not include anything pertaining to Ajaxplorer upgrades
I am currently on Ajaxplorer 5.0.3
I am trying to migrate to Pydio
I use my Ajaxplorer installation through a web server proxy. So my SME install is behind a firewall through a front facing proxy.
Any tips on doing the upgrade. I can suffer little to no downtime. And trying to setup a test VM is difficult due to my SME being 4TB.

Title: Re: Pydio upgrade from Ajaxplorer
Post by: Daniel B. on July 29, 2014, 08:23:29 AM

Long time since I did my last migration from Ajaxplorer to Pydio, but there was no known issue I can remember. Just yum update, and pydio will replace Ajaxplorer. Then you have to finish with signal-event webapps-update or post-upgrade + reboot

Then, depending on how you access it, you might need a few steps left:

- If you were using a vhost, you'll need to adjust the DocumentRoot from /usr/share/ajaxplorer to /usr/share/pydio
- If you were using the alias /ajaxplorer, it's now /pydio (you can create a custom template to add /ajaxplorer back)

Title: Re: Pydio upgrade from Ajaxplorer
Post by: Daniel B. on July 29, 2014, 08:24:23 AM

Of course, you should test this on a VM, even if you don't load the full 4Tb of data