Koozali.org: home of the SME Server

Contribs.org Forums => Koozali SME Server 10.x => Topic started by: jameswilson on February 10, 2020, 01:26:49 PM

Title: Install from scratch testing raid setup
Post by: jameswilson on February 10, 2020, 01:26:49 PM

Installed alpha4, set to uk keyboard, London timezone
Server Only install to 1 drive
Install did not setup degraded raid 1.
Reinstalling with 2 drives
Same, no raid 1
Just a report not a question fyi

James

Title: Re: Install from scratch testing raid setup
Post by: Jean-Philippe Pialasse on February 10, 2020, 07:44:18 PM

Degraded array is not possible with nee anaconda.

For the absence of raid when using 2 drives can you describes the steps you took? Gui vs cli install?

Title: Re: Install from scratch testing raid setup
Post by: Fidalgo on March 22, 2020, 07:28:51 PM

10a4: When two identical disks are used without any partition, Anaconda do not build a raid1. That happened with me, according to the documentation: 
https://access.redhat.com/documentation/en-us/red_hat_enterprise_linux/7/html/storage_administration_guide/raidinstall

Title: Re: Install from scratch testing raid setup
Post by: jameswilson on May 13, 2020, 11:48:04 AM

Yes tested with
1 disk on install then added a second after install
2 identical clean disks on install

no degraded or raid 1 etc.
all done on proxmox v6

Title: Re: Install from scratch testing raid setup
Post by: jameswilson on May 13, 2020, 11:48:33 AM

ill dig out the rocket info i have and ask for some jobs to do!

Title: Re: Install from scratch testing raid setup
Post by: ReetP on May 13, 2020, 06:32:29 PM

Quote from: jameswilson on May 13, 2020, 11:48:33 AM

ill dig out the rocket info i have and ask for some jobs to do!

Shout if you have lost them. We have LOTS to do!!