Koozali.org: home of the SME Server
Legacy Forums => General Discussion (Legacy) => Topic started by: Richard Dols on October 05, 2002, 06:29:05 AM
-
Hello,
I managed to install the upnp gateway of sourceforge on sme 5.5. But i didn't get it to work, but i don't know much about linux. maybe one of you can see wan't goes wrong or had a idea. Please reply.
I can be reached by messenger on kabouter139@hotmail.com
---------------------------
download all files from page
http://myezserver.com/downloads/mitel/contrib/dev-tools/SME55/
and run ./install.sh
Install the next rpm.
e2fsprogs-devel-1.26-1.71.i386.rpm
get the following file, but DON'T install it.
upnpsdk-1.0.4.tar.gz.tar
it can be found on http://upnp.sourceforge.net
Get the following file, but DON't install it.
gateway-0.75.tgz
it can be found on http://sourceforge.net/projects/linux-igd/
Read the "install" file from the gateway-0.75.tgz package. modify the ssdplib.c file as mentioned. Then install the upnpsdk package and the gateway package.
most likely you don't need to give the route command, but check this.
Start upnpd as mentioned in the the "install" file again.
-
look on the upnp forum..
http://sourceforge.net/forum/forum.php?thread_id=951440&forum_id=174960
* The upnp calls in messenger are made through some parts of DirectX.
http://sourceforge.net/forum/message.php?msg_id=2206180
You need to upgrade to DirectX version 9 for it to work flawlessly
* If you don’t want to upgrade you have to patch the libupnp-1.2.1, see this post http://sourceforge.net/forum/message.php?msg_id=2206180