Koozali.org: home of the SME Server

Legacy Forums => General Discussion (Legacy) => Topic started by: Prabhjot Gill on May 11, 2000, 08:34:27 PM

Title: Install problems
Post by: Prabhjot Gill on May 11, 2000, 08:34:27 PM

I tried to run setup by inserting boot disk and then After I type in proceed in the setup of e-smith the computer says initializing cd-rom and it gave me ERROR
message : "Does not appear to ba a REDHAT CD", although CD has e-smith image
on it.

I will appreciate your help.

Title: RE: Install problems
Post by: Prabhjot Gill on May 11, 2000, 10:27:07 PM

I will like to add a little more to this problem. I made CD from the image file after
downloading e-smith-3.1/e-smith-3.1-cdrom.iso.gz compressed file. When I un-compressed file, it was with e-smith-3.1-cdrom.iso,
so I just put that file on the CD. Is there any further procedure to use this file to burn a CD?

I don;t see any folders on the CD except e-smith-3.1-cdrom.iso file.

I will appreciate your help.Prabhjot Gill wrote:

> I tried to run setup by inserting boot disk and then After I
> type in proceed in the setup of e-smith the computer says
> initializing cd-rom and it gave me ERROR message : "Does
> not appear to ba a REDHAT CD", although CD has e-smith
> image on it.
>
> I will appreciate your help.

Title: RE: Install problems
Post by: Brando Choy on May 12, 2000, 12:04:41 AM

You will have to open the image file. Grab Wincdr/nero/Ez CD creator ... In order to burn image files to cd-rom.

Copying the image to disk does nothing.  There are tons of info on the net on how to burn image files. Good luck.

BC

Title: RE: Install problems
Post by: Walter Kremers on May 13, 2000, 02:34:32 AM

If you have EasyCD Creator, look in FILE/Create CD from image. Works all the time!