Koozali.org: home of the SME Server

Legacy Forums => General Discussion (Legacy) => Topic started by: Kif on December 30, 2002, 01:10:20 AM

Title: BT Speedway PCI card not found!
Post by: Kif on December 30, 2002, 01:10:20 AM

Hi
Having problems getting my server to see my BT speedway card internal PCI ISDN card (AVM Fritz)

dmesg gives the following (relevant) output

ISDN subsystem Rev: 1.114.6.7/1.94/1.140.6.3/1.85.6.2/1.21/1.5.6.2 loaded
HiSax: Linux Driver for passive ISDN cards
HiSax: Version 3.5 (module)
HiSax: Layer1 Revision 2.41.6.1
HiSax: Layer2 Revision 2.25
HiSax: TeiMgr Revision 2.17
HiSax: Layer3 Revision 2.17.6.1
HiSax: LinkLayer Revision 2.51
HiSax: Approval certification failed because of
HiSax: unauthorized source code changes
HiSax: Total 1 card defined
HiSax: Card 1 Protocol EDSS1 Id=HiSax (0)
HiSax: AVM PCI driver Rev. 1.22.6.3
FritzPCI: No PCI card found
HiSax: Card AVM Fritz PnP/PCI not installed !
ISDN-subsystem unloaded

There is no problem wi the card itself, if i throw it into a windows machine it works fine.
I cant understand why the card isnt being seen.  Is this an IRQ thing?
cat /proc/pci gives the following (relevant) output
 
Bus  0, device   6, function  0:
    Network controller: AVM Unknown device (rev 1).
      Vendor id=1244. Device id=e00.
      Medium devsel.  Fast back-to-back capable.  IRQ 10.  
      Non-prefetchable 32 bit memory at 0xe8001000 [0xe8001000].
      I/O at 0xd400 [0xd401].

cat /proc/interrupts doesnt list either the card or IRQ10

I'm a bit new to all this... So far everything else has gone like a dream, I just need to get this connection sorted and the sky's the limit
Can anyone help please?

Thanks a million...
Kif

Title: Re: BT Speedway PCI card not found!
Post by: Kif on December 31, 2002, 12:46:36 AM

lspci gives the following output:

00:06.0 Network controller: AVM Audiovisuelles MKTG & Computer System GmbH:
Unknown device 0e00 (rev 01)
 Subsystem: AVM Audiovisuelles MKTG & Computer System GmbH: Unknown device
0e00
 Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
 Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- SERR-  Interrupt: pin A routed to IRQ 10
 Region 0: Memory at e8001000 (32-bit, non-prefetchable)
 Region 1: I/O ports at d400
 Capabilities: [40] Power Management version 2
  Flags: PMEClk- DSI- D1- D2+ AuxCurrent=55mA
PME(D0-,D1-,D2+,D3hot+,D3cold+)
  Status: D0 PME-Enable- DSel=0 DScale=0 PME-