Koozali.org: home of the SME Server

Legacy Forums => General Discussion (Legacy) => Topic started by: TMMXONE on May 21, 2003, 06:07:58 PM

Title: a liitle help with cbq on sme 5.6
Post by: TMMXONE on May 21, 2003, 06:07:58 PM

through many hours of searching and reading , i am blocked.

ok sbq is integrated with SME 5.6
can be found at /etc/sysconfig/cbq

dmesg | grep eth0
eth0: RealTek RTL8139 Fast Ethernet at 0xcc8ba000, 00:e0:4c:de:86:c7, IRQ 11
eth0: Identified 8139 chip type 'RTL-8139C'
eth0: Setting 100mbps full-duplex based on auto-negotiated partner ability 45e1.

eth0 is ok at  100 mbps

there is my cbq-10.clients placed at /etc/sysconfig/cbq

DEVICE=eth0,100Mbit,10Mbit
RATE=30Kbit
WEIGHT=4Kbit
PRIO=5
RULE=192.168.0.10

i tried to start
[root@compaq-sme cbq]# cbq start
Illegal "weight"
"?at is "
Usage: ... cbq bandwidth BPS rate BPS maxburst PKTS [ avpkt BYTES ]
[ minburst PKTS ] [ bounded ] [ isolated ]
[ allot BYTES ] [ mpu BYTES ] [ weight RATE ]
[ prio NUMBER ] [ cell BYTES ] [ ewma LOG ]
[ estimator INTERVAL TIME_CONSTANT ]
[ split CLASSID ] [ defmap MASK/CHANGE ]
"?at is "
Usage: ... tbf limit BYTES burst BYTES[/BYTES] rate KBPS [ mtu BYTES[/BYTES] ]
[ peakrate KBPS ] [ latency TIME ]
[root@compaq-sme cbq]#

So whats wrong ?!

thanks for any help

Title: Re: a liitle help with cbq on sme 5.6
Post by: hanscees on May 22, 2003, 01:30:41 AM

why dont you run wondershaper? See the advanced routing howto. See another post of me

hc

Title: Re: a liitle help with cbq on sme 5.6
Post by: TMMXONE on May 22, 2003, 01:51:16 AM

thanks
i am going to do that

Title: Re: a liitle help with cbq on sme 5.6
Post by: Jaime Nebrera on May 22, 2003, 08:43:40 PM

Hi,

  Or you could use eneo-qos-cbq :) A new english/french/spanish release is about to get out.

  Regards