Koozali.org: home of the SME Server

Legacy Forums => General Discussion (Legacy) => Topic started by: Geoff on June 11, 2003, 09:33:44 AM

Title: Adaptec 7892 adapter
Post by: Geoff on June 11, 2003, 09:33:44 AM

I have an IBM x220 eServer which has an Adaptec 7892 SCSI controller and two 36Gb SCSI HDD.

The Mitel5.6 CDD boots up, loads the aic-7XXX driver, and sits there with:

"Running anaconda - please wait ......"

Any suggestions. please?

Title: Re: Adaptec 7892 adapter
Post by: Graeme Fleming on June 11, 2003, 05:55:03 PM

The AIC7892 chip is the basis for most of the Adaptec U160 cards (as well as being used embedded).

Drivers (rpm) for RH7.3 can be found at:
http://www.adaptec.com/worldwide/support/driverdetail.html?sess=no&language=English+US&cat=/Product/ASC-29160&filekey=aic7xxx-6.2.10-rh73.i686.rpm

Check on the experienced forum for info on how to get the system to use the driver on install.

HTH

Title: Re: Adaptec 7892 adapter
Post by: Upaboveit on June 12, 2003, 01:21:16 PM

I had SME5.0 installed in a 1U with an onboard 7892 and didn't need any special drivers. Complete autodetection and installation. Sounds more like the hard drives haven't been formatted by the Adaptec yet.