Koozali.org: home of the SME Server
Legacy Forums => General Discussion (Legacy) => Topic started by: Del on November 10, 2003, 09:38:40 PM
-
Hi All,
I have just installed Darrell May's Raid Monitor rpm and when I run:
[root@linux-server root]# raidmonitor -v
I get:
ALARM! RAID configuration problem
Current configuration is:
Personalities : [raid1]
read_ahead 1024 sectors
md2 : active raid1 hda3[0] hdc3[1]
264512 blocks [2/2] [UU]
md1 : active raid1 hda2[0] hdc2[1]
59678528 blocks [2/2] [UU]
[====>................] resync = 23.2% (13845540/59678528) finish=197.5mi
n speed=3867K/sec
md0 : active raid1 hda1[0] hdc1[1]
104320 blocks [2/2] [UU]
unused devices:
Last known good configuration was:
Personalities : [raid1]
read_ahead 1024 sectors
md2 : active raid1 hda3[0] hdc3[1]
264512 blocks [2/2] [UU]
md1 : active raid1 hda2[0] hdc2[1]
59678528 blocks [2/2] [UU]
[====>................] resync = 20.0% (11949176/59678528) finish=204.4mi
n speed=3889K/sec
md0 : active raid1 hda1[0] hdc1[1]
104320 blocks [2/2] [UU]
unused devices:
Any ideas what is wrong? Any help is appreciated.
Regards,
Del
-
You ran raidmonitor -iv too early, while the array was still resyncing. Wait until it's finished, then run it again.
-
Hi Ray,
Thanks for the quick response, I am a bit confused over whether I should run
raidmonitor -iv or raidmonitor -v
Also do you have any tips on guessing when it has finished resynching! I've managed to catch it during resync 5 out of 5 times! (If only I could somehow use this to choose my Florida lotto #'s!!). Thanks again for your help.
Regards,
Del
PS Congrats on a great site (www.familybrown.org)
-
"Ray"? It should be done in a little over 3 hours from your first post in thread, based on the "finish=197.5mi" in the note. You can use 'cat /proc/mdstat' to verify that it's done before running the raidmonitor -iv again.
-
Ray,
Thanks for all your help
Regards,
Del
-
It's spelled RAID, not RAY ;-)
-
...or "Dan"...