Topic: installing scsi tape drive on 5.6

[tanfxl4]

Hello I am trying to install the drivers for an Adaptex scsi controller which is the model Adaptec AHA2930CU.
This connected to a Travan tape drive.

Can anyone advise thge procedure and were I can find the controller for this card. I believe the Adaptec AHA2930U model is compatible so I will use the controler for this, but where is it? Is it already in a folder on the SME 5.6 server?

I have searched high and low on only found Darrel Mays input which was quite good but did not have all the answers..
Sorry guys, I am a little green on this one. Any help is appreciated... TIA Greg

[RavenIV]

do an "upgrade" to your server.
just put in the 5.5-sme CD and do again a setup.
the setup will find your adaptec and do nothing else to aour system than installing the driver for the adaptec.

cheers klaus

[Anonymous]

Thanks for the info...

Tried the upgrade and still wouild not function. I would say it is not finding the card. Also tried with a new Tekram card which is Linux OK and still not found???. Is there some other config that is needed?

TIA Greg