Topic: Setup problems w/SCSI drives

[Eric Pedersen]

Hello all,

I can't seem to get the installation going on my PC with 2 SCSI drives and an Adaptec 2940U/UW.  The procedure starts and then says it's missing the "/tmp/kickstart.cfg" file.

I've tried it using the boot disks as well, but still no luck.

Any suggestions would be appreciated.

Regards,

Eric

[Dan G.]

Are you doing the RAID1 install?

Just for kicks --- have you tried disconnecting one of the drives?

[Eric Pedersen]

Hi,

Thanks for the super-fast reply.

At the point it fails, it hasn't even gotten around to asking if I want a RAID 1 install yet.  I'll try disconnecting one of the drives when I re-try the install tonight.

[Eric Pedersen]

Hi,

Thanks for the super-fast reply.

At the point it fails, it hasn't even gotten around to asking if I want a RAID 1 install yet.  I'll try disconnecting one of the drives when I re-try the install tonight.

[Eric Pedersen]

I've booted with the 'boot.img' diskette and all seems to be proceding normally.  Not sure why booting from the CD itself should cause so much trouble.

Oh well - onwards and upwards.

Eric