After installing Jesper's current SpamAssassin script all e-mail is returned to sender. I can't send outgoing mail. If I turn SpamAssassin off at the panel, all mail works normally.
The returned e-mail message;
Your message cannot be delivered to the following recipients:
Recipient address: xxx@xxxx.org
Reason: SMTP transmission failure has occurred
Diagnostic code: smtp;554 Permanent qmail-queue failure.
Remote system: dns;mail.xxxx.org (TCP|206.46.252.44|49827|71.241.xxx.xxx|25) (mail.xxxx.org mailfront ESMTP)
I ran a test from
http://www.dnsstuff.com/ I get -
[Successful connect: Got a good response [250 Recipient accepted.]] while the server is returning all mail.
I'm using SME 6.01 with Clam AV and all working well. I installed Jesper's current SpamAssasin script. My first attempt looked like a good install but the panel did not show up. I re ran the script and everything appeared successful but all mail is rejected if I turn on SpamAssassin. I un-installed the 3 RPM's and re-installed from the script with the same results. Any ideas on how I can fix this?
1 Replies
875 Views