Topic: How can i "reconfigure" my SME Server?

[recoco]

I'm a newbie to SME.I want to change my install config for SME Server,such as eth ip,route, and so on.I tried to change these values on /etc/sysconfig.But found the warning message:DO NOT MODIFY THIS FILE!
I have searched the admin manual but can't find it.Can anybody help me?Thanks in advance!

[crazybob]

From a keyboard and monitor attached to the server, or using putty, login as admin, and the admin/root password. This will take you to the configuration screens.

This is explained in a strange area accessable on the left side of your browser called Documentation

see section  5.5. Configuring your SME Server and section 6.2 in the users manual

Bob

[JonB]

Log into the console as admin and admin password or use SSH and log in as admin and the admin password.

You will get the Server Console screen.

Choose option 2 "Configure this server"

This will bring you to the configuration screen you got when you first installed the server.

[recoco]

got it.Thank you very much!I have never logined as admin.I usually login as root....

[judgej]

From a keyboard and monitor attached to the server, or using putty, login as admin, and the admin/root password. This will take you to the configuration screens.

I never realised you could access that screen from putty. Nice tip!

[raem]

judgej

> I never realised you could access that screen from putty. Nice tip!

Also if you are logged in as root you can run the command
/sbin/e-smith/console

[TheMonk]

Also if you are logged in as root you can run the command
/sbin/e-smith/console

Code: [Select]


su - admin


Should do the same thing