Topic: After upgrading to v7.1, Hylafax broken:

[cb-wizard]

After upgrading to v7.1, Hylafax broken:

e-mail message:

Your facsimile job was not sent because document conversion to facsimile failed.  The output from the converter program was:

/usr/bin/gs: error while loading shared libraries: libgs.so.7: cannot open shared object file: No such file or directory
/usr/bin/gs: error while loading shared libraries: libgs.so.7: cannot open shared object file: No such file or directory
/bin/cat: write error: Broken pipe


Check any PostScript documents for non-standard fonts and invalid constructs

 Done on 3 x servers, same problem, shown some issues with Ghostscript .

[psoren]

After upgrading to v7.1, Hylafax broken:

e-mail message:

Your facsimile job was not sent because document conversion to facsimile failed.  The output from the converter program was:

/usr/bin/gs: error while loading shared libraries: libgs.so.7: cannot open shared object file: No such file or directory
/usr/bin/gs: error while loading shared libraries: libgs.so.7: cannot open shared object file: No such file or directory
/bin/cat: write error: Broken pipe


Check any PostScript documents for non-standard fonts and invalid constructs

 Done on 3 x servers, same problem, shown some issues with Ghostscript .

You could try to remove hylafax, and then install again it with yum to sort dependancies:

# yum localinstall hylafax-and-so-on.rpm (In the dir where you have the rpm)



Per

[cb-wizard]

Getting the following error:


FATAL ERROR: No tiffg3 driver in /usr/bin/gs.


HylaFAX has been configured to use Ghostscript as the PostScript imaging program
but the output of /usr/bin/gs -h does not list the tiffg3 driver as a configured driver


The tiffg3 driver is required for HylaFAX to operate correctly.


Chris